PAN-S树脂富集钴的分光光度法测定研究

陈山

引用本文:	陈山.PAN-S树脂富集钴的分光光度法测定研究[J].环境监控与预警,2014,6(4):26-29
	CHEN Shan.Analytical Characteristics and Application of 1-(2-Pyridylazo)-2-naphthol-6-sulphnic Acid Impregnated Resin for Adsorption of Cobalt[J].Environmental Monitoring and Forewarning,2014,6(4):26-29

【打印本页】【HTML】【下载PDF全文】【查看/发表评论】【EndNote】【RefMan】【BibTex】

←前一篇|后一篇→

过刊浏览高级检索

本文已被：浏览 9653次下载 4079次	码上扫一扫！
分享到：微信更多字体:加大+\|默认\|缩小-
PAN-S树脂富集钴的分光光度法测定研究
陈山¹
盐城市环境监测中心站，江苏盐城 224002

摘要:

研究了PAN-S浸渍树脂对Co2+的吸附性能。Co2+吸附pH值范围为4.7～9.2,最佳pH值为5.4；达到最大吸附容量需25 min，树脂对Co2+平衡吸附容量是98 mg/g干树脂，达到最大吸附容量平衡时用0.1 mol/L的HNO3洗脱，洗脱率达98%。该方法建立了PAN-S-树脂富集-分离钴离子的分光光度测定方法，结果令人满意。

关键词: 钴 PAN-S树脂分光光度法

DOI：

分类号:X830.2

基金项目:

Analytical Characteristics and Application of 1-(2-Pyridylazo)-2-naphthol-6-sulphnic Acid Impregnated Resin for Adsorption of Cobalt

CHEN Shan

Abstract:

This paper has studies theresearch of PAN S impregnating resin on the properties of the adsorption of Co2+. The adsorption pH range of Co2+ is 4.7~4.7 and the optimum pH is 5.4; the time needed to reach maximum adsorption capacity of Co2+is 25 min and resin adsorption capacity for Co2+ balance is 98 mg/g dry resin; elution rate was 98% when the adsorption capacity reached maximum balance and eluted with 0.1 mol/L HNO3.The spectrophotometric method of PAN-S-resin enrichment and separation of cobalt ions were established and satisfactory results were obtained.

Key words: Cobalt PAN-S resin Spectrophotometric method